The Motorola H500 headset uses Bluetooth technology to wirelessly connect to devices so that it can deliver the audio output from those devices to your ear. Bluetooth headsets are normally used with mobile phones, but they can also be paired with computers, mp3 players or other electronics. The Motorola H500 has only one button on it, so it can be a bit confusing learning do all the commands with just the one button. However, after using the headset for some time it becomes second nature.
Instructions
Pairing
1. Plug one end of the charge into the port on the end of the headset and the other end of the charger into the wall outlet. Let the device charge completely, which will take about two hours, before you unplug the headset and continue.
2. Press down and hold the call button, which is the large button on the front of the headset. Keep holding it until the light on the headset turns a steady blue, which takes about six seconds.
3. Go into the Bluetooth menu on your phone and have it search for new devices. This process will be different on each individual phone, so consult your owner's manual if you can't find do this.
4. Select "Motorola H500" from the list of devices and enter "0000" when you are asked to enter a password. Your H500 and your phone are now paired.
Wearing
5. Flip the earhook to the open position, which will be at a 90 degree angle from the rest of the headset.
6. Slide the back of the hook over your right ear and then press the headset down so it sits over your ear.
7. Reverse the headset, so you can wear it on the left ear, by opening the hook and then prying the top of the hook out of the hinge pin. Remove the hook, flip the earpiece over, then insert the bottom of the hook back into place before snapping the top into the hinge pin.
Using
8. Turn the headset on by holding the call button until the indicator light flashes. Then release the button before the headset enters pairing mode. Turn the headset off by holding the call button until the light flashes rapidly before turning off.
9. Tap the call button to answer a call, end a call or make a voice dial call, depending on the current state of the headset.
10. Press and hold the call button to reject a call, redial the last number, answer a second call while you are already on the phone or to toggle between two calls.
11. Press the upper volume button to raise the volume and the lower one to lower it. The upper is based on the earpiece being positioned in the right ear. If you switch ears, turn the headset off and then press and hold the call button and the volume key you want to make the "Volume up" button. The lights will flash telling you that the command went through.
12. Press and hold both volume buttons to join two callers into a three-way call or to disable the indicator light. You can also press and release both volume buttons to mute the headset.
Tags: call button, hold call, hold call button, Motorola H500, both volume, both volume buttons, button until